컨텐츠명

: Design Guidelines - 1

작성일

: 2008.02.05

조회수

: 589

1. Input Shaft, Circular Spline, and housing must be concentric.
2. The oil drain also enables assembly verification.
3. The Flexspline pilot diameter must be concentric to Circular Spline.
4. A clamping ring with corner radius increases torque transmission capacity and prevents damage to the Flexspline diaphragm.
5. A radial shaft seal for oil lubrication.
6. Double bearing support for output shaft.
7. Axial location of Flexspline.
8. Air vent depending on the application.
9. Flexspline and Circular Spline must be located both parallel and perpendicular to the output shaft.
10. Axial location of Wave Generator.
11. Oil input. (also enables assemble verification)
12. Double bearing support for input shaft.